Operation; Key Function - Smartgen HGM7100N Series User Manual

4

OPERATION

4.1 KEY FUNCTION

Icon
Stop/ Reset
Start
Manual
Auto
C/O
Close
Open
Set/Confirm
Up/Increase
Down/Decrease
Homepage/Return
NOTE: press any key to mute alarms in main screen.
HGM7100N Genset Controller
Table 3 - Key Function Descriptions
Function
Stop running generator in Auto/Manual mode;
In stop mode, reset alarms;
Pressing and holding the button for 3 seconds will test indicator
lights (lamp test);
During stopping process, press this button again to stop generator
immediately.
Under manual mode, press this button and genset can be started;
Pressing this key will set the module into manual mode.
Pressing this key will set the module into auto mode.
Press this key to control breaker close or open under manual mode.
(only suit for HGM7120N)
Press this key to control breaker close under manual mode.
(only suit for HGM7110N)
Press this key to control breaker open under manual mode.
(only suit for HGM7110N)
Pressing this key will enter into Main Menu;
In setting parameter status, press this key to shift cursor or confirm
setting value.
Scrolls the screen up; Shift the cursor up or increase the set value
in parameter setting menu.
Scrolls the screen down; Shift the cursor down or decrease the set
value in parameter setting menu.
Return to homepage in main interface; return to previous interface
in parameter setting screen; press for over 3s to reset trip alarms.
HGM7100N GENSET CONTROLLER USER MANUAL
Description
2020-09-10 Version1.2 Page 7 of 47