Table of Contents
Advertisement
9 SENSOR SETTING
a)
Sensor types that can be connected inside controller are all resistance sensors; Parts of
standard curves (Table 10) have been put inside the controller for users. If customized sensor
curves are planned to use, users must set by PC software;
b)
When customized sensor curve is set, X value (resistance) must be inputted from small to big,
otherwise mistake may occur;
c)
When "Not Used" is selected for sensor, sensor curve won't work, and at the same time LCD
won't display sensor data;
d)
Y value of the foremost points and the last few points can be set the same as below:
MGC300 Series Genset Controller User Manual
Fig. 6 Sensor Curve
Page 22 of 26
Advertisement
Table of Contents
