Smartgen HGM7100N Series User Manual page 31

No. Type
33 Starter Relay Output
34 Fuel Relay Output
35 Idle Control
36 Raise Speed
37 Drop Speed
38 ETS Control
39 Pulse Drop Speed
40 Reserved
41 Reserved
42 Pulse Raise Speed
43 Crank Success
44 Generator OK
45 Generator Available
46 Mains OK
47 Loading Speed Output
48 Common Alarm
Common Electrical Trip and
49
Stop
50 Common Shutdown
51 Common Trip Alarm
52 Common Warning Alarm
53 Reserved
54 Battery High Voltage
55 Battery Low Voltage
56 Charge Alt Fail
57 Reserved
58 Reserved
59 Reserved
60 ECU Warning Alarm
61 ECU Shutdown Alarm
62 Reserved
63 Reserved
64 Reserved
65 Reserved
66 Reserved
67 Reserved
68 Reserved
69 Digital Input 1 Active
70 Digital Input 2 Active
HGM7100N Genset Controller
HGM7100N GENSET CONTROLLER USER MANUAL
Act at generator start, disconnect at waiting to stop.
Used for gensets with idle speed control; Pull in before crank,
disconnect at entering warming up period; Pull in at stop idle
process, and disconnect at genset complete stop.
Act in the period of warming up.
Act in the period of stop idle and wait to stop running time.
Used for engines with ETS electromagnet. Close when stop idle
is over and open when pre-set "ETS delay" is over.
Close when a successful start signal is detected.
Act when generating is normal.
Act in period of generator ok to hi-speed cooling.
Act when Mains is normal.
Act at genset common warning, common shutdown, common
trips alarm.
Act when common trip and stop alarm occurs.
Act when common shutdown alarm occurs.
Act when common trips alarm occurs.
Act when common warning alarm occurs.
Act when battery's over voltage warning alarm occurs.
Act when battery's low voltage warning alarm occurs.
Act when charge failure warning alarm occurs.
Indicate ECU sends a warning signal.
Indicate ECU sends a shutdown signal.
Act when input port 1 is active
Act when input port 2 is active
2020-09-10
Description
Version1.2 Page 31 of 47