Smartgen HGM7100N Series User Manual page 17

6.3 TRIP AND STOP ALARM
When controller detects trip and stop alarms, it will immediately disconnect the generator closing
signals and engine will shut down after high-speed cooling.
No. Type
1 Over Current
Maintenance
2
Due
3 Reverse Power
4 Over Power
5 Input Trip and Stop
6.4 TRIP ALARM
When controller detects trip alarms, it will immediately disconnects the generator closing signals and
genset does not shut down.
No. Type
1 Over Current
2 Reverse Power
3 Over Power
4 Input Trip
HGM7100N Genset Controller
Table 7 - Trip and Stop Alarms
When controller detects the current value of genset is higher than the
set value and action select "Trip and Stop", it will send trip and stop
signals.
Time When maintenance time countdown equals to 0, and action select
"Trip and Stop", it will send trip stop signals.
When controller detects that the reverse power value (power is
negative) of genset exceeds the pre-set value, and action type select
"Trip and Stop", it will send trip and stop signals.
When controller detects that the power value (power is positive) of
genset exceeds the pre-set value, and action type select "Trip and
Stop", it will send trip and stop signals.
When input port configured as "Trip and Stop", and it is active,
controller will send trip and stop signals.
Table 8 - Trip Alarms
When controller detects the current value of genset is higher than the set
value and action select "Trip", it will send trip signals.
When controller detects that the reverse power value (power is negative)
of genset exceeds the pre-set value, and action type select "Trip", it will
send trip signals.
When controller detects that the power value (power is positive) of genset
exceeds the pre-set value, and action type select "Trip", it will send trip
signals.
When input port configured as "Trip", and it is active, controller will send
trip signals.
2020-09-10
HGM7100N GENSET CONTROLLER USER MANUAL
Description
Description
Version1.2 Page 17 of 47