Definition Content Of Programmable Output Ports 1~6 - Smartgen HGM7100N Series User Manual

8.2

DEFINITION CONTENT OF PROGRAMMABLE OUTPUT PORTS 1~6

No. Type
0 Not Used
1 Custom Period 1
2 Custom Period 2
3 Custom Period 3
4 Custom Period 4
5 Custom Period 5
6 Custom Period 6
7 Custom Combined 1
8 Custom Combined 2
9 Custom Combined 3
10 Custom Combined 4
11 Custom Combined 5
12 Custom Combined 6
13 Reserved
14 Reserved
15 Reserved
16 Reserved
17 Air Flap Control
18 Audible Alarm
19 Louver Control
20 Fuel Pump Control
21 Heater Control
22 Cooler Control
23 Pre- fuel
24 Excite Generator
25 Pre-lubricate Output
26 Remote PC Output
27 Reserved
28 Reserved
29 Close Generator
30 Open Breaker
31 Close Mains
32 Reserved
HGM7100N Genset Controller
HGM7100N GENSET CONTROLLER USER MANUAL
Table 11 - Programmable Output Ports 1~6
For details of function description please see the following
contents.
Act at over speed shutdown and emergency stop; Engine air
inletting can be closed.
Act at warning, shutdown, electric trip; Annunciator can be
connected externally; When flexible input "Alarm Mute" is
active, it can be prohibited to output.
Act at generator start, disconnect after genset complete stop.
It is controlled by level sensor fuel pump controlling the upper
and lower limits.
It is controlled by temp sensor heating and controlling the
upper and lower limits.
It is controlled by temp sensor cooling and controlling the
upper and lower limits.
Act in the period from crank to safety on time.
Output in the crank process; output for 2s again if Gen
frequency is lost in high speed period.
Act in the period from pre-heating to safety on time.
This port is controlled by communication (PC).
Control generator breaker to take load.
Control generator breaker to take off load.
Control Mains breaker to take on load.
2020-09-10
Description
Version1.2 Page 30 of 47