[Al. 021_Encoder Normal Communication Error 2] - Mitsubishi Electric MR-J5-G Series User Manual

[AL. 021_Encoder normal communication error 2]

• The encoder detected an error signal.
[AL. 021.1_Encoder data error 1]
Cause
1.
An excessive speed or acceleration was
detected due to an oscillation or other factors.
2.
The external conductor of the encoder cable is
not connected to the ground plate of the
connector.
3.
The encoder has malfunctioned.
4.
There is a problem with the surrounding
environment.
[AL. 021.2_Encoder data update error]
Cause
1.
The encoder has malfunctioned.
2.
The external conductor of the encoder cable is
not connected to the ground plate of the
connector.
3.
There is a problem with the surrounding
environment.
[AL. 021.3_Encoder data waveform error]
Page 40 [AL. 021.2_Encoder data update error]
[AL. 021.4_Encoder non-signal error]
Cause
1.
A signal of the encoder has not been input.
2.
The external conductor of the encoder cable is
not connected to the ground plate of the
connector.
3.
There is a problem with the surrounding
environment.
[AL. 021.5_Encoder hardware error 1]
Page 40 [AL. 021.2_Encoder data update error]
[AL. 021.6_Encoder hardware error 2]
Page 40 [AL. 021.2_Encoder data update error]
1 SERVO AMPLIFIER TROUBLESHOOTING
40
1.3 Handling methods for alarms/warnings
Check/action method
Decrease the control gain, then check the repeatability. If the error does not
repeat, use the encoder with a lower gain.
Check if the external conductor of the encoder cable is connected to the
ground plate of the connector.
Refer to "Shield procedure of CN2, CN2A, CN2B, and CN2C side connectors"
in the following manual.
Rotary Servo Motor User's Manual (HK series)
Replace the servo motor.
Check the noise, ambient temperature, and other conditions, and implement
appropriate countermeasures for the cause.
If there is noise, take countermeasures to reduce the noise.
Refer to "Noise reduction techniques" in the following manual.
MR-J5 User's Manual (Hardware)
Check/action method
Replace the servo motor.
Check if the external conductor of the encoder cable is connected to the
ground plate of the connector.
Refer to "Shield procedure of CN2, CN2A, CN2B, and CN2C side connectors"
in the following manual.
Rotary Servo Motor User's Manual (HK series)
Check the noise, ambient temperature, and other conditions, and implement
appropriate countermeasures for the cause.
If there is noise, take countermeasures to reduce the noise.
Refer to "Noise reduction techniques" in the following manual.
MR-J5 User's Manual (Hardware)
Check/action method
Check if the encoder cable is wired correctly.
Check if the external conductor of the encoder cable is connected to the
ground plate of the connector.
Refer to "Shield procedure of CN2, CN2A, CN2B, and CN2C side connectors"
in the following manual.
Rotary Servo Motor User's Manual (HK series)
Check the noise, ambient temperature, and other conditions, and implement
appropriate countermeasures for the cause.
If there is noise, take countermeasures to reduce the noise.
Refer to "Noise reduction techniques" in the following manual.
MR-J5 User's Manual (Hardware)
Model
[A]
[G]
[WG]
Model
[A]
[G]
[WG]
Model
[A]
[G]
[WG]