[AL. 0EA_ABS servo-on warning]
• The servo amplifier did not become servo-on status within 1 s after ABSM (ABS transfer mode) was turned on.
[AL. 0EA.1_ABS servo-on warning]
Cause
1.
The wiring of input/output signals is incorrect.
2.
The sequence program is incorrect.
Check/action method
Check for disconnection or loose connection in the I/O signal wire.
Modify the sequence program so that servo-on is enabled within 1 s after
ABSM (ABS transfer mode) is turned on.
1 SERVO AMPLIFIER TROUBLESHOOTING
1.3 Handling methods for alarms/warnings
1
Model
[A]
111