Communication Environment Setup - Canon iR3245 Network Manual

Communication Environment Setup

This section describes how to set up the environment for communication between the machine and
computers on your network. If you are configuring the settings for the first time, use thecontrol panel
of the machine.
After configuring the settings, you can change them using software other than the control panel of the
machine. For details, see "Network Setting Items(p.8-2)."
Remark
[SNMP Settings] does not support AppleTalk networks.
1. On the Network Settings screen, press [SNMP Settings] → specify the
settings for SNMP v. 1.
[On] for <Use SNMP v. 1>: Follow the procedure below to specify the MIB access
permissions and community names.
The machine supports the SNMP v. 1 and SNMP v. 3 management functions. You can use
themsimultaneously. The [Read Only]/[Read/Write] functions of SNMP v. 1 and the security functions of
SNMP v. 3, such as an encrypted communication path, enable you to manage devices more securely. The
available combinations of SNMP v. 1 and SNMP v. 3 functions you can use are shown below:
SNMP v. 1
Use SNMP MIB
v. 1 Access
Permission
On Read/
Write
On Read Only On
SNMP v. 3
Use SNMP
v. 3
On/Off You can set or browse each item of the machine with a
utility that uses SNMP v. 1 to obtain information. As the
write access with SNMP v. 1 is enabled, the security
functions of SNMP v. 3 are not available, regardless of the
settings for <Use SNMP v. 3>.
You can only browse each item of the machine with a
utility that uses SNMP v. 1 to obtain information. Only
users who have been assigned access rights can set
each item of the machine with a utility that uses SNMP v.
3.
Description
Communication Environment Setup
2
2-13