Setting Up A Computer As A File Server - Canon iR3245 Network Manual

Setting Up a Computer as a File Server

To send data from the machine to a computer on your network, you need to specify the settings of the
computer for receiving data.
This section describes how to set up a computer as a file server.
4
Remark
Optional equipment is required to send data. For the
equipment needed, see "Optional Equipment and
System Requirements(p.1-2)."
To send a file to the NetWare server, specify the
following NetWare settings for the machine. For
instructions on how to specify the protocol settings, see
"Protocol Settings(p.4-12)."
<NetWare>: [On]
<Frame Type>: Frame type suitable for your
environment
1. Log in to NetWare as Administrator (or as a user of equivalent authority)
→ set up the users and passwords for sending data from the machine.
Enter a user name, and a password not longer than 24 alphanumeric characters.
2. Create a directory to be used for recipient addresses, and then enable
read access and write access by the users who will be sending data.
3. Set a recipient address from the control panel.
There are two methods for specifying the recipient address; selecting the desired address
from the list that appears when you press [Browse], or entering the address using the
4-20 Setting Up a Computer as a File Server
This section describes only the procedures for setting
up a computer receiving data sent from the machine.
To send data from the machine to a server on the
network, you must enter an address setting from the
control panel. For instructions on how to specify
recipient address settings, see the Sending and
Facsimile Guide.
In some environments, additional detailed settings,
such as authority settings, may be required. For
details, consult the network administrator of the
environment you are using.