3. Enter the security policy name to register in [Policy Name] → press
[Selector Settings].
4. On the Selector Settings screen, specify the local IP address to apply the
registered security policy to.
When receiving IP packets, the registered security policy is applied if the destination IP
address in the packets matches the local IP address specified in this procedure. When
sending IP packets, the registered security policy is applied if the source IP address in the
packets matches the local IP address specified in this procedure.
IPSec is not applied for link local addresses included when the following are selected. IPSec packets sent
to link local addresses are discarded.
[All IP addresses] for <Local Address>
[IPv6 Address] for <Local Address>
[IPv6 Manual Settings] for <Local Address>
Applying a Security Policy to All Sent and Received IP Packets:
●
Applying a Security Policy to the IP Packets Received from and Sent to the IPv4 Address
●
Held By the Machine:
Applying a Security Policy to the IP Packets Received from and Sent to the IPv6 Address
●
Held By the Machine:
Applying a Security Policy to the IP Packets Received from and Sent to the Specified IPv4
●
Address or IPv4 Network Address:
Applying a Security Policy to the IP Packets Received from and Sent to the Specified IPv6
●
Address or IPv6 Network Address:
Registering a Security Policy
3
3-59