Netbios Network Setup Procedures - Canon iR3245 Network Manual

NetBIOS Network Setup Procedures

To use a NetBIOS network, it is necessary to perform the following procedures.
1 Protocol Settings (See " Protocol Settings (p.5-3) .")
5
Specify the protocol settings. To specify the settings, use:
The machine's control panel
The Remote UI (via a web browser)
2 Computer Settings for Printing/Sending a Fax (See " Setting Up a Computer
for Printing/Sending a Fax (p.5-7) ."
Specify the settings of each computer you use for printing or sending a fax. (Optional equipment is
required to print or send a fax from a computer. For the equipment needed, see "Optional Equipment
and System Requirements(p.1-2).")
3 Computer Settings for a File Server (See " Setting Up a Computer as a File
Server (p.5-15) .")
Specify the settings of the computer receiving data sent from the machine. (Optional equipment is
required to send data. For the equipment needed, see "Optional Equipment and System
Requirements(p.1-2).")
Remark
It is recommended that steps 1 and 3 above be
performed by the network administrator.
5-2 NetBIOS Network Setup Procedures
The only base protocol supported by the machine for
NetBIOS networks is TCP/IPv4. TCP/IPv6 and
NetBEUI are not supported (SMB is used as a print
application).