Canon iR3245 Network Manual page 240

Remedy
7
Cause 2
Remedy
Cause 3
Remedy
Cause 4
Remedy
Unable to Send Data/Share Files (NetWare)
7-12 Data Sending/File Sharing Problems and Remedies
Perform the following to check the server status. (If you are using
Windows, perform these from the command prompt.)
Example using UNIX, where the FTP server has the IP address: 192.168.1.195
U:>ftp 192.168.1.195 *Connect to server
Connected to 192.168.37.195.
220 canmfs FTP server (UNIX(r) System V Release 4.0) ready.
User (192.168.37.195:(none)): user_name *User login
331 Password required for user_name.
Password: *Enter password
230 User user_name logged in.
ftp>cd /export/share *Move to data destination directory
250 CWD command successful.
ftp> bin *Set data transfer type (binary)
200 Type set to I.
ftp> put sample.tif *Set transfer file name for verification
ftp> by *Cut off server connection
221 Goodbye
If the above are confirmed and file sharing still does not operate normally, consult the
network administrator for the environment you are using.
The machine's address [User] setting contains one or more spaces after
the user name.
Ensure that the machine's address [User] setting does not contain
spaces after the user name.
The machine was turned OFF while sending data to the FTP server, and
when the machine was turned back ON, it attempted to resend the data.
(If a Windows 2000/XP/Server 2003/Vista FTP server is being used.)
If power to the machine is turned OFF while data is being sent to the
FTP server, the FTP server may hold the data in a writing-in-progress
state. Therefore, this data cannot be overwritten even when the machine
reconnects and sends the same data again. Stop the FTP server
temporarily and delete the held data, so it can be sent again.
An error message is displayed on the touch panel display of the
machine.
After confirming the error message, perform the necessary operations
according to the error message displayed.