Tcp/Ipv4 Settings - Canon iR3245 Network Manual

TCP/IPv4 Settings

This section describes the procedure for setting TCP/IPv4 using the control panel. After specifying
3
the settings for TCP/IPv4, follow the procedure in "Settings Common to TCP/IPv4 and TCP/
IPv6(p.3-23)" to specify the required settings, and the procedure in "Confirming TCP/IPv4
Settings(p.3-33)" to check whether the network settings are correct. If the settings for TCP/IPv6 are
already specified and you have finished specifying the settings common to TCP/IPv4 and TCP/IPv6,
only check the network settings after completing this procedure.
If you want to use IPv6 communications at the same time, follow the procedure in "TCP/IPv6
Settings(p.3-13)," to specify the required settings, and the procedure in "Confirming TCP/IPv6
Settings(p.3-35)," to confirm the settings.
1. On the TCP/IP Settings screen, press [IPv4 Settings] → [Use IPv4].
3-4 TCP/IPv4 Settings