Canon iR3245 Network Manual page 235

Check the following Macintosh settings:
Confirm that the proper printer driver is installed.
Remedy
Confirm that the proper printer has been selected as the destination.
Confirm that [AppleTalk] is active.
Confirm that the AppleTalk connection method is EtherTalk or Ethernet.
Cause 5
The name of the file being printed is too long.
Normally LPR sends jobs either under the name of the application
software used for printing or under the file name. However, a job name
Remedy
longer than 255 characters cannot be sent tothe printer. To correct this
problem, rename the file with a shorter name.
The IP address of the computer from which data (print/fax/I-fax job) is to
be sent to the machine is not permitted by the settings for <RX/Print
Cause 6
Range> in [IP Address Range Settings] on the IPv4 or IPv6 Settings
screen.
Check the settings for <RX/Print Range> in [IP Address Range Settings]
Remedy
on the IPv6 Settings screen. (See step 8 in "TCP/IPv4 Settings(p.3-4),"
or step 6 in "TCP/IPv6 Settings(p.3-13).")
An error message is displayed on the touch panel display of the
Cause 7
machine.
After confirming the error message, perform the necessary operations
Remedy
according to the error message displayed.
Unable to Print from a NetWare Network
Cause 1
The machine and cable are not properly connected.
Turn OFF the machine's power switches, check that the machine is
Remedy
connected to the network using the proper cable, and then turn them
ON. (See "Connecting the Machine to a Computer or Network(p.2-3).")
Cause 2
The NetWare network is not properly set up.
Printing Problems and Remedies
7
7-7