Canon iR3245 Network Manual page 237

Cause 1
The machine and cable are not properly connected.
Turn OFF the machine's power switches, check that the machine is
Remedy
connected to the network using the proper cable, and then turn them
ON. (See "Connecting the Machine to a Computer or Network(p.2-3).")
Cause 2
TCP/IP network is not properly set up.
On the assumption that the TCP/IP is working correctly if you print using
NetBIOS network, check the following:
Confirm that the IPv4 addresses are properly set up. If the IPv4 addresses were set using DHCP,
BOOTP, or RARP, confirm that they are operating.
Remedy
If you are using a DHCP server, confirm that the WINS server is working correctly with the DHCP
server.
Cause 3
NetBIOS network is not properly set up.
Remedy
Confirm that SMB and WINS are properly set up.
The IPv4 address of the computer from which data (print/fax/I-fax job) is
Cause 4
to be sent to the machine is not permitted by the settings for <RX/Print
Range> in [IP Address Range Settings] on the IPv4 Settings screen.
Check the settings for <RX/Print Range> in [IP Address Range Settings]
Remedy
on the IPv4 Settings screen. (See step 8 in "TCP/IPv4 Settings(p.3-4).")
Cause 5
The computer that is printing is not properly set up.
Check the following:
Confirm that the proper printer driver is installed. If you are printing from Windows, each computer
must have a printer driver installed.
Remedy
For instructions on how to install printer drivers, see Getting Started.
Confirm that the correct printer is set as the output destination for the computer that is printing.
Confirm the output destination in [Printer] in [Control Panel].
An error message is displayed on the touch panel display of the
Cause 6
machine.
After confirming the error message, perform the necessary operations
Remedy
according to the error message displayed.
Your computer may not be able to recognize the machine even though the IP address
settings are appropriate. This problem may be resolved by delaying the startup of
network communications for the machine. (See "Startup Time Settings(p.3-78).")
Printing Problems and Remedies
7
7-9