Canon iR3245 Network Manual page 231

destination via its dial-up access (when a dial-up router is connected to your network).
The machine periodically or temporarily communicates with devices on
your network. If a dial-up router or NetWare file server is on the network
to which the machine is connected, the machine connects to a
destination other than the intended destination, depending on
thesettings of the machine or dial-up router. This may result in
subscriber line charges and callcharges.
Cause
Examples:
The file or mail server's host name or IP address set on the machine does not exist on the network.
The DNS server exists on an external network.
You attempt to access a device connected to an external network, if the device's information is set
on the DNS server on the network to which the machine is connected.
Check the following:
If the dial-up router does not have to send packets via broadcast, change the router settings to
ensure that it sends packets via a method other than broadcast. If dial-up router has to send
packets via broadcast, check that the settings are correct.
Remedy
Check that the file or mail server's host name or IP address set on the machine is correct.
If you attempt to access a device on the network to which the machine is connected, with the DNS
server on an external network, set the destination using an IP address, not a host name.
If information about a device on an external network is set on the DNS server on the network to
which the machine is connected, check the settings.
Detailed information concerning the machine cannot be set or browsed using the
Remote UI or utility.
The IP addresses of computers on which the Remote UI or utility is used
Cause 1
are not allowed in <Setting/Browsing Range> in [IP Address Range
Settings] on the IPv4 or IPv6 Settings screen.
If the settings for <Setting/Browsing Range> in [IP Address Range
Settings] on the IPv4 or IPv6 Settings screen do not permit the IP address
of a computer on which the Remote UI or utility is used, you cannot
Remedy
specify machine setting items or browse information on the machine.
Check the settings for <Setting/Browsing Range> in [IP Address Range
Settings] on the IPv4 or IPv6 Settings screen. (See step 8 in "TCP/IPv4
Settings(p.3-4)," or step 6 in "TCP/IPv6 Settings(p.3-13).")
Cause 2
<Use SNMP v. 1> or [Enable Dedicated Port Settings] is set to 'Off'.
Network Connection Problems and Remedies
7
7-3