Canon iR3245 Network Manual page 234

Remedy
Unable to Print from a TCP/IP Network
Cause 1
Remedy
7
Cause 2
Remedy
Cause 3
Remedy
Cause 4
7-6 Printing Problems and Remedies
If you are using a NetBIOS network and the IPv4 address of the
computer in which a driver is to be installed is not permitted by the
settings for both <RX/Print Range> and <Setting/Browsing Range> in [IP
Address Range Settings] on the IPv4 Settings screen, the driver cannot
be installed successfully. Check the settings for both <RX/Print Range>
and <Setting/Browsing Range> in [IP Address Range Settings] on the
IPv4 Settings screen. (See step 8 in "TCP/IPv4 Settings(p.3-4).")
The machine and cable are not properly connected.
Turn OFF the machine's power switches, check that the machine is
connected to the network using the proper cable, and then turn them
ON. (See "Connecting the Machine to a Computer or Network(p.2-3).")
TCP/IP network is not properly set up.
Check the following:
Confirm that the IPv4 addresses are properly set up. If the IPv4 addresses were set using DHCP,
BOOTP, or RARP, confirm that they are operating.
Confirm that the IPv6 addresses are properly set up. After checking the settings of the router, set
<Use Stateless Address> to 'On' to confirm whether you can obtain an address. If the IPv6
addresses were set using DHCPv6, confirm that DHCPv6 is operating.
Your computer may not be able to recognize the machine even though the IP address
settings are appropriate. This problem may be resolved by delaying the startup of
network communications for the machine. (See "Startup Time Settings(p.3-78).")
The computer that is printing is not properly set up. (Windows)
Check the following:
Confirm that the proper printer driver is installed. If you are printing from Windows, each computer
must have a printer driver installed. For instructions on how to install printer drivers, see Getting
Started.
Confirm that the correct printer is set as the output destination for the computer that is printing.
Check the output destination in [Printer] in [Control Panel].
The computer that is printing is not properly set up. (Macintosh)