Communication Environment Setup - Canon imageRUNNER ADVANCE 8105 Getting Started

Communication Environment Setup

This section describes how to set up the environment for communication between the machine and computers on your network.
If you are configuring the settings for the first time, use the control panel of the machine.
After configuring the settings, you can change them using software other than the control panel of the machine. For details, see
e-Manual > Settings/Registration.
[SNMP Settings] does not support AppleTalk networks.
1
On the Network screen, press [SNMP Settings] → specify the settings for SNMP v . 1 .
[On] for <Use SNMP v. 1>: Follow the procedure below to specify the MIB access permissions and community names.
•
The machine supports the SNMP v. 1 and SNMP v. 3 management functions. You can use them simultaneously. The [Read Only]/[Read/
Write] functions of SNMP v. 1 and the security functions of SNMP v. 3, such as an encrypted communication path, enable you to manage
devices more securely.
The available combinations of SNMP v. 1 and SNMP v. 3 functions you can use are shown below:
Use SNMP v . 1
On
On
On
Off
Off
•
If you want to use a Canon printer driver or utility, press [On] for both <Use SNMP v. 1> and [Dedicated Port Settings].
•
You can restrict the IP addresses of computers on which items can be set or browsed. If you restrict IP addresses, it is not possible to
set or browse detailed information concerning the machine on computers other than those whose IP addresses are allowed to send or
receive data, even if <Use SNMP v. 1>, <Use SNMP v. 3>, and [Dedicated Port Settings] are set to 'On' . For details, see "TCP/IPv4 Settings, "
on p. 4-3 or see "TCP/IPv6 Settings, " on p. 4-9.
SNMP v . 1 SNMP v . 3
MIB Access
Use SNMP v . 3
Permission
Read/Write On/Off
Read Only On
Read Only Off
- On
- Off
Description
You can set or browse each item of the machine with a utility that uses SNMP
v. 1 to obtain information.
As the write access with SNMP v. 1 is enabled, the security functions of SNMP
v. 3 are not available, regardless of the settings for <Use SNMP v. 3>.
You can only browse each item of the machine with a utility that uses SNMP
v. 1 to obtain information.
Only users who have been assigned access rights can set each item of the
machine with a utility that uses SNMP v. 3.
You can only browse each item of the machine with a utility that uses SNMP
v. 1 to obtain information.
Only users who have been assigned access rights can set or browse each
item of the machine with a utility that uses SNMP v. 3.
You cannot set or browse each item of the machine with a utility.

Communication Environment Setup

3
3-9