Netbios Network Setup Procedures - Canon IMAGERUNNER 4570 Network Manual

NetBIOS Network Setup Procedures

To use a NetBIOS network, it is necessary to perform the following procedures.
1
2
5
3
IMPORTANT
•
It is recommended that steps 1 and 3 above be performed by the network manager.
•
The only base protocol supported by a NetBIOS network is TCP/IP. (SMB is used as the
print application.) NetBEUI is not supported with the machine.
•
Use the control panel or NetSpot Device Installer if you are configuring the TCP/IP
settings for the first time. After configuring the settings, you can change the content by
using the Remote UI or NetSpot Console.
5-2

NetBIOS Network Setup Procedures

Protocol Settings (See "Protocol Settings," on p. 5-3.)
Specify the protocol settings. To specify the settings, use:
•
The machine's control panel
•
The Remote UI (via a web browser)
•
NetSpot Console (via a web browser) (Canon utility)
Computer Settings for Printing (See "Setting Up a Computer for Printing/Sending a Fax," on
p. 5-11.)
Specify the settings of each computer you use for printing or sending a fax. (You can only print or send a fax
from a computer if the optional equipment is installed. For the equipment needed, see "Optional Equipment
and System Environment Requirements," on p. 1-2.)
Computer Settings for a File Server (See "Setting Up a Computer as a File Server," on p. 5-17.)
Specify the settings of the computer receiving data sent from the machine. (You can only send data if the
optional equipment is installed. For the equipment needed, see "Optional Equipment and System
Environment Requirements," on p. 1-2.)