TCP/IP Network Setup Procedures
To use a TCP/IP network, it is necessary to perform the following procedures.
1
Protocol Settings (See "Protocol Settings," on p . 4-3 .)
Specify the protocol settings. To specify the settings, use:
•
The machine's control panel
•
The Remote UI (via a web browser)
•
Canon utilities
2
Computer Settings for Printing (See e-Manual > Network .)
Specify the settings for each computer you use for printing. (Optional equipment is required to print from a computer. For the equipment needed, see "Optional Equipment and
4
System Requirements for Connecting to a Network, " on p. 2-2.)
3
Computer Settings for a File Server (See "Setting Up a Computer as a File Server," on p . 4-28 .)
Specify the settings of the computer receiving data sent from the machine.
•
It is recommended that steps 1 and 3 above be performed by the network administrator.
•
The machine or printing equipment does not come with printer driver software that can be used on a UNIX platform. (Use LPD to set up a
printer in UNIX.)
•
If you are using the imagePASS, see the manual provided with the imagePASS.
•
If you are using the imagePASS, some functions are not available with this machine. For details, see the manual provided with the imagePASS.
•
A pre-determined port must be opened in order to initiate network communication using TCP/IP. The required port can be opened by selecting
[On] for all of the [Network] settings in the machine. It is recommended that any unused functions be set to [Off]. When a port is opened, it is
possible for a third person to gain unauthorized access.
4-2
TCP/IP Network Setup Procedures