Sleep Mode Timeout - Datalogic Gryphon I GD4100 Product Reference Manual

Sleep Mode Timeout

This feature sets the amount of time that the reader will be idle before it enters into a low power
Sleep Mode. When in Sleep Mode the reader can no longer receive commands from the Host or
base station until it is woken up again by a trigger pull or being placed into a base station.
In order for the reader to enter Sleep Mode, the following conditions must be met:
Corded version (GD4100 only).
pulse.
Mobile version (GM4100 only). Sleep state is allowed only on the handheld (not on the base)
when trigger single, trigger multiple or trigger pulse are set, and when the reader is not charging
the battery.
Sleep Mode Timeout = Disable
Sleep Mode Timeout = 2 Seconds
$
Sleep Mode Timeout = 4 Seconds
94
RS-232 interface and trigger single, trigger multiple or trigger
This feature is not applicable to the Gryphon Laser or Gryphon BT models
Gryphon™ I GD4100/GM4100/GBT4100/L GD4300
ENTER/EXIT PROGRAMMING MODE
DEFAULT
Sleep Mode Timeout = 1 Second
Sleep Mode Timeout = 3 Seconds