System Status Tab; Application Tabs - Thermo Scientific LevelPRO User Manual

Operation
Mode/Fault Alarm Setup

System Status Tab

Application Tabs

-
4 12 LevelPRO User Manual
After selecting an operational mode, the user may select an output source for the alarm
action. The actions available are:
– Do Nothing (Do not take any actions)
– Relay Output A
– Relay Output B
– Current Output A
– Current Output B
– Current Output C
Once an output source has been selected, an alarm action can be selected on either the
Current Output or Relay Outputs
these screens, see these respective sections.
As previously stated, the System Status tab displays the alarms from the System tab and
shows whether or not the alarms are currently in an active state.
To access the information on the Mode/Fault Alarm Setup System Status tab using
only the remote transmitter keypad, see
Figure 4-7. Mode/Fault Alarm Setup, System Status Tab
The Application tabs are organized so that the alarm's operational mode is in the left
column, with the options for action on the right. The bottom of the tab includes
information on the status of each alarm, showing whether or not they are currently in
an active state.
To access the information on the Mode/Fault Alarm Setup Application tabs using only
the remote transmitter keypad, see
screens, as appropriate. For further information on
Figure A-14.
Figure A-15.
Thermo Scientific