Thermo Scientific LevelPRO User Manual page 82

Operation
Application Screens
-
4 42 LevelPRO User Manual

5202 source head

5203 source head

5204 source head

5206 source head

5207 source head

5208 source head

5210 source head

5211 source head

6000 source head
2. Specify an Isotope from the dropdown list.

Cs137

Co60

Am241

Other
3. Choose General Level or Cascade Level from the Level Type dropdown.
a. If Cascade Level is selected as the Level Type, the Select Cascade Level field
will become operational.
i. Choose Detector #1, Detector #1 and Detector #2, or Detector #1,
Detector #2 and Detector #3.
4. Enter the length and the unit of measure for Detector #1.
a. If Detector #1 and Detector #2, or Detector #1, Detector #2 and Detector #3
are selected in the Select Cascade Level dropdown, the fields next to these
detectors will become available.
5. Select a unit of measure from the Level Unit dropdown. The selection made on
this tab will provide the unit information for the Action and Measurement Data
tabs.

% – percentage

ft – feet

in – inch

yd – yard

cm – centimeter

m – meter

Not Used
6. Next, specify the level measurement span minimum and maximum.
7. Finally, indicate if Vapor Density Compensation will be used.
Thermo Scientific