Advertisement
Appendix B
Flash Application Firmware
The first time you apply power to the detector, the screen shown in Figure B-1 should
display on your laptop. If this screen does not appear, the detector has been at least
partially set up. If you are unsure about what settings that have been entered, or if the
detector has been moved to a new location, it is recommended that the detector be
reset to the factory defaults and set up again. To reset all entries in EZ Cal II,
including the communication settings, to the factory defaults, go to Commands
Common Action Erase all Ram and set defaults (Cold Start), then click the Refresh
button.
If access to this screen is desired at a later time, it may be accessed by selecting PC
Comm Setup from the Functions dropdown menu at the top of the screen, or by
clicking the first icon button, which is circled in Figure B-1.
Figure B-1. Local PC Communication Setup Screen
Thermo Scientific
LevelPRO User Manual
B-1
Advertisement
