Advertisement
Thermo Scientific
Alarms have three operational modes.
–
Disable – The alarm is disabled, and no alarm action is executed.
–
Enable – The alarm is enabled. The selected alarm action is executed based on the
alarm set condition.
–
Inhibit – The alarm is temporary disabled. Another operation may change the
mode of this alarm from Inhibit to Enable.
After selecting an operational mode, the user may select an output source for the alarm
action. The actions available are:
–
Do Nothing (Do not take any actions)
–
Relay Output A
–
Relay Output B
–
Current Output A
–
Current Output B
–
Current Output C
Once an output source has been selected, an alarm action can be selected on either the
Current Output
or
Relay Outputs
see these respective sections.
screens. For further information on these screens,
LevelPRO User Manual
Operation
Mode/Fault Alarm Setup
4-7
Advertisement
