Figure 3-4 Operating Modes - Xantrex Watt Series Programmable DC Power Supply XG 850 Operating Manual

Figure 3-4 Operating Modes

To set
1. Turn the 9-position mode control to the VOLTS position or press the
2. Set the desired voltage value using the rotary Adjust/Enter control.
Important:
change the set points for OVP.
3. Press the rotary Adjust/Enter control to transition to Fine Adjust
4. Set the desired voltage value using the rotary Adjust/Enter control.
5. Once the desired value has been set, press the rotary Adjust/Enter
M370078-01
voltage
the set point
rotary Adjust/Enter control if the 9-position mode control is already
at the VOLTS position.
The voltage set point is blinking in the output voltage display. The
output current will be displayed in the output current display.
If you can't get the set point to the desired level, you may need to
mode.
The set point will blink faster to indicate fine adjust tracking mode.
control to commit the setting.
(V
SET):
Standard Operation
3-13
3