Non-Isolated Resistive Programming Of Voltage Calibration - Xantrex Watt Series Programmable DC Power Supply XG 850 Operating Manual

Non-isolated Resistive Programming of Voltage Calibration

Important:
calibration procedure again but use the intended operating resistance level in
steps 2 and 3.
To calibrate the non-isolated resistive programming of voltage:
1. Disconnect the load and connect the voltmeter to the output.
2. Connect the 4.000kΩ resistor to the non-isolated connector, resistive
3. Set the resistive APG level to 4kΩ. The SCPI command is:
4. Set the input source as Resistive Non-Isolated for Voltage
5. Turn the main output On by pressing the OUTPUT ENABLE Main
6. Enter the interactive calibration mode by sending the SCPI command:
7. Press the terminal keys – or + to reduce or increase main output
8. Press any key other than the + or – keys to exit from interactive
M370078-01
For maximum accuracy at a specific APG level. Follow the
programming of voltage, and voltage programming (J1.9-J1-11, and
J1.7).
SYST:COMM:APR:LEV
Programming. The SCPI command is:
SYST:REM:SOUR ARES
button on the front panel or send the command:
:OUTP ON
The OUTPUT ENABLE Main button will illuminate.
CAL:OUTP:ANAL:RES
voltage value. Adjust the main output voltage to 100%.
calibration mode.
Calibration and Troubleshooting
4
6
6-13