Resetting The Power Supply - Xantrex Watt Series Programmable DC Power Supply XG 850 Operating Manual

Resetting the Power Supply

The reset is used to clear the parameters to the factory default values.
Soft Reset The soft reset is used to set the parameters (see Table 3-9) to the default
values, but it does not reset the calibration constants
To perform a soft reset:
1. Turn the power supply to Off then On.
2. Press the key combination of both OUTPUT ENABLE Main button
3. Once a reset has been triggered, the output voltage display shows P5U
After executing a reset, the power supply's settings are restored to the
default settings but retain the calibration data. Table 3-9 lists the default
settings.
Table 3-9 Power Supply Default Settings
Parameter
Address
Data rate (Kbps)
Communication mode
Vout setting
Iout setting
Output
AUX Out
Trigger
Ext. On/Off Polarity
Auto start mode
AUX Auto start mode
OVP
M370078-01
When the unit is powering on, 8888 8888 is displayed on the output
voltage and current displays.
and OUTPUT ENABLE Aux button and hold continuously for 3
seconds in order to execute.
If the flash fail alarm triggers, it is also possible to reset the power
supply.
CLr for 1 second.
The model number will be displayed for 1 second and then return to
normal mode.
Resetting the Power Supply
Setting
1
9.6
RS-232
0 V
0 A
Off
Off
Off
Negative
Off
Off
Maximum
3
3-39