Table of Contents
Advertisement
Error
It stops while operating.
The System is running but there
is an error.
The system is working but it does
not do the elution.
There is a leakage in the syringe
block.
The liquid is dripping in the
bottom of the system.
The heater is not working.
There is a burning smell in the
system.
UV Lamp does not work.
A4(210X297)
1.
Check if the power supplied into the system.
2.
Check if the Power switch has been pressed.
3.
In the lower part of LCD screen, check if there is a delay in the
blue progress bar.
4.
Check if you have pressed 'Pause" by mistake.
5.
Request for After Service.
1.
Check if wrong protocol has been used.
2.
Check if there is an error in the motor while operating during the
movement of syringe block due to residues or accessories
being stuck.
3.
Check if it is operating after rerunning the same program.
4.
Request for After Service.
1.
Check if Elution rack and tubes are inserted appropriately.
2.
Check if the tips are inserted completely.
3.
Check if the end of the tip is clogged.
4.
Check if sample is inserted into the cartridge.
5.
Check if there is any leakage in the syringe block.
6.
Request for After Service.
1.
Stop using the well that were being used and request of after
service.
1.
Check if the rack and the waste tray and other accessories are
inserted in the right position.
2.
Check if there is a leakage in the syringe block.
3.
Request for After Service.
1.
Check if the rack and the waste tray and other accessories are
inserted in the right position.
2.
Check if any solution is dripped in the base plate during the
usage.
3.
Request for After Service.
1.
Disconnect the power and unplug the power connector
immediately.
2.
Request for After Service.
1.
Check if the door is closed completely.
2.
Request for After Service.
-44-
ExiPrep
Fully Automated Nucleic Acid Extraction System
Solution
TM
16 Dx
Advertisement
Table of Contents
