Installing The Exiprep™16 Dx - Bioneer ExiPrep 16 Dx User Manual

IV. Installing the ExiPrep™16 Dx
- Clear and clean the area where the instrument will be installed.
- Open the instrument door and remove the holding accessories.
- Make sure that all components are included. Refer to the list of components on
A4(210X297)
Fully Automated Nucleic Acid Extraction System
1. Open the door and remove the Screw (A) from the rail.
2. Remove the Holding plate (B) from the rail and the Syringe
Block.
3. Remove the Screw (C) from the locking block which
immobilizes the belt.
4. Separate the holding block (D, E) from the belt and
remove it.
-8-
TM
ExiPrep 16 Dx
page 6.