Table of Contents
Advertisement
3.
RUN ( Not used PC) (Continued)
A4(210X297)
Fully Automated Nucleic Acid Extraction System
7.
Select the 'elution volume' from the LCD touchscreen.
8.
After selecting the desired 'elution volume' press 'ok' to
complete PREP SETUP.
9.
Open the instrument door and pull out the Base Plate.
10. Place all racks and Buffer Cartridges in their respective locations
on the Base Plate according to the CHECK LIST
the LCD touchscreen.
11. Verify the name of the target nucleic acid type and sample
source type on the Running Mode screen, and press the 'RUN'
button.
Progress of the extraction run can be checked through the
progress bar on the lower portion of the LCD touchscreen.
12. You may press the 'STOP' button during the run to terminate the
extraction.
If you press 'STOP' during an extraction run, a popup
prompt asking you whether you are sure ('Are you sure?')
will appear. Select 'Yes' to terminate the run, or 'No' to
cancel the stop and proceed with the extraction run.
You may select 'PAUSE' to temporarily stop the run and
'RUN' to resume.
-15-
TM
ExiPrep
16 Dx
page) on
(17
Advertisement
Table of Contents
