Bioneer MagListo-8Ch Manual

[Cat. No.] TM-1000, TM-1010, TM-1011
Introduction
MagListo™ Magnetic Separation Rack is a separation tool used for
nucleic acid extraction and protein purification using magnetic
nanobeads. By using the magnetic nanobeads, the separation and
purification processes can be performed faster than spin-column
based extraction method. Solutions can easily be disposed of
without needing a pipette, as the silicon packing holds the tubes
even when it is upside down.
These products are optimized for nucleic acid extraction and protein
purification with MagListo™ 5M nucleic acid extraction kits and
protein purification kits, respectively.
Components
Stand
Components TM-1000
Stand 1 ea
Magnet plate 1 ea
1. Stand
• The body part for holding the tubes: There are holes for inserting
the tubes from the top and also for attaching magnet plate to the
front part of the stand.
• Use only the tubes recommended by BIONEER. If a tube is too
tight, the silicon packing may get torn or come off. If a tube is too
loose, the tube may fall off while disposing the solution.
2. Magnet plate
• The part that attaches to the stand: There are magnets fixed on
one side of the magnet plate that gets attached to the stand.
Specifications
MagListo™-8Ch Magnetic Separation Rack
Stand
Dimension
(W x D x H)
Magnet plate
Weight
Capacity
* Note: There may be a slight difference from the actual size.
MagListo™-2 Magnetic Separation Rack
Stand
Dimension
(W x D x H)
Magnet plate
Weight
Capacity
* Note: There may be a slight difference from the actual size.
™
MagListo Magnetic Separation Rack
™
(MagListo -8Ch, MagListo
Magnet plate
TM-1010 TM-1011
1 ea 1 ea
1 ea 1 ea
104 mm x 23 mm x 31 mm
104 mm x 8 mm x 23 mm
105 g
1 ml tube x 8 holes
136 mm x 27 mm x 33 mm
136 mm x 9.5 mm x 25 mm
150 g
2 ml tube x 8 holes
Copyright 2022 BIONEER Corporation. All Rights Reserved.
www.bioneer.com
™ ™
-2, MagListo -2-12h)
MagListo™-2-12h Magnetic Separation Rack
Stand
Dimension
(W x D x H)
Magnet plate
Weight
Capacity
* Note: There may be a slight difference from the actual size.
Precautions and Warnings
• Do not drop the product or apply a strong shock. It may cause the
product to break.
• Be cautious when storing or handling the product. Dropping the
product may cause injury.
• If the product is damaged, use a tool to dispose of the damaged
product. Sharp edges of the damaged surface may cause injury.
• Only use the tubes recommended by BIONEER. Using a non-
recommend tube may cause the silicon packing to tear or the
tube to fall off.
• Immediately rinse the product with running water if any solution
from kits get on the magnet. Make sure to wipe off the water with
dried clothes before storage. The magnets may get corroded and
come off the magnet plate if stored with its surface stained.
• Ensure the product is dry before storage.
• Immediately clean the product if any organic solvent gets onto it.
MagListo™ is composed of PMMA, and it may get damaged from
organic solvents including ethanol, acetone, toluene, etc. If the
product gets damaged from an organic solvent, the service fee
may be charged or you may need to repurchase the product.
• Store the product with the stand and the magnet plate attached.
• DO NOT store the magnet plates facing each other. If multiple
magnet plates have to be stored together, store all components
separately or have the magnet plates face the same direction.
If the magnet plates are stored facing each other, the magnets
may fall off from the strong magnetic forces.
<Correct>
• Do not use the product if you have a cardiac pacemaker. The
magnetic field generated by the product may interfere with it.
• Do not remove the pad on the magnet plate. It is to prevent the
corrosion of the magnets.
Online Resources
Korean
Visit our product page for additional information and protocols
1
(V4/2022-02-25)
194 mm x 27 mm x 33 mm
194 mm x 9.5 mm x 25 mm
210 g
2 ml tube x 12 holes
<Wrong>
English
BQ-042-101-03
Revision : 7 (2021-04-12)