Bioneer ExiPrep 16 Dx User Manual page 38

VIII. Updating the ExiPrep
※ The IP address may change depending on the installation site and PC.
A4(210X297)
TM
16 Dx (Continued)
7. If the connection fails, the 'connect fail' prompt
will be displayed. In this case, reboot the
instrument and network hub, and verify that the
network cable is connected correctly. Also verify
the PC network settings including the IP
address
8. After the connection is completed, click the
'Update' button on the right side. Wait until the
progress bar is full.
9. Once the connection process is done, 'Memory
Check starts' window will pop up.
10. Click 'OK'.
11. Once 'Memory Check' starts, the progress
status bar will be displayed.
12. When the Memory Check finishes the progress,
'Write and Read memory check results to
matches' window will pop up.
13. Press 'OK' button.
14. If you get the 'Finish' message on the progress
bar, all the update process.
15. Disconnect the LAN cable from the computer
and the instrument.
16. Reboot the instrument and reconnect the LAN
cable.
-36-
ExiPrep
Fully Automated Nucleic Acid Extraction System
If the connection stops progressing, restart
the update process from step 1.
If the connection stops progressing, restart
the update process from step 1.
TM
16 Dx