Gearbox Oil - BRP can-am RENEGADE 500 2015 Operator's Manual

vmo2010-004-016_a
1. CVT air filter
5. Clean inside the CVT air inlet end
CVT Air Filter Installation
1. Install air filter on CVT inlet by
stretching its sides.
2. Resinstall gauge support.

Gearbox Oil

Gearbox Oil Level Verification
NOTICE
Check level and refill if
necessary. Do not overfill. Operat-
ing the gearbox with an improper
level may severely damage gear-
box. Wipe off any spillage.
Place the vehicle on a level surface.
Select NEUTRAL position.
Apply parking brake.
Check the gearbox oil level by remov-
ing the gearbox oil level plug.
vmo2012-012-056_a
TYPICAL - 800R ENGINE
1. Drain plug
2. Oil level plug
vmo2012-012-057_a
TYPICAL - 1000 ENGINE
1. Drain plug
2. Oil level plug
The oil should be level with the bottom
of the oil level hole.
Refill as required until gearbox oil level
flows through oil level hole.
Recommended Gearbox Oil
ENGINE
500,
800R
1000
If the recommended oil is not available,
use a 75W140 gearbox oil that meets
the API GL-5 specification.
NOTICE
of oil when servicing. Do not mix
with other types of oil.
Gearbox Oil Change
NOTE: When replacing the gearbox
oil, it is recommended to clean the ve-
hicle speed sensor (VSS) at the same
time.
Place the vehicle on a level surface.
Clean drain plug area.
Clean the oil level plug area.
Under the vehicle, place a drain pan un-
derneath the oil drain plug area.
Remove the oil level plug.
Remove the gearbox drain plug.
______________
MAINTENANCE PROCEDURES
RECOMMENDED
PRODUCT
XPS SYNTHETIC
GEAR OIL
(75W 140)
(P/N 293 600
140)
Do not use another types
QUANTITY
Approx. 400 ml
(13.53 U.S. oz)
Approx. 450 ml
(15.22 U.S. oz)
105