BRP can-am RENEGADE 500 2015 Operator's Manual page 100

MAINTENANCE PROCEDURES
NOTE: While checking the oil level, vi-
sually inspect engine area for leaks.
vmo2006-007-013_a
TYPICAL - RH SIDE OF ENGINE
1. Dipstick
With vehicle on a level surface and en-
gine cold, not running, check the oil
level as follows:
1. Unscrew dipstick then remove it
and wipe clean.
2. Reinstall dipstick, screw in it com-
pletely.
3. Remove and check oil level. It
should be near or equal to the up-
per mark.
V07C02B
TYPICAL
1. Full
2. Add
To add oil, remove dipstick. Place a
funnel into the dipstick tube to avoid
spillage.
Add a small amount of recommended
oil and recheck oil level.
______________
98
1
2
Repeat the above procedures until
oil level reaches the dipstick's upper
mark. Do not overfill.
Properly tighten dipstick.
Recommended Engine Oil
For the summer season, use XPS
4-STROKE SYNTH. BLEND OIL (SUM-
MER) (P/N 293 600 121).
For all season, use XPS 4-STROKE
SYNTHETIC OIL
(P/N 293 600 112).
NOTE: The XPS oil is specially formu-
lated and tested for the severe require-
ments of this engine.
If not available, use 4-stroke SAE
5W40 engine oil that meets or exceeds
the requirements for API service clas-
sification SG, SH or SJ. Always check
the API service label certification on
the oil container it must contain at least
one of the above standards. Refer to
the viscosity chart for details.
Engine Oil Change
Start and warm-up engine. Stop en-
gine.
Ensure vehicle is on a level surface.
Remove dipstick.
Clean the oil drain plug area.
Place a drain pan under the oil drain
plug area.
Unscrew oil drain plug.
CAUTION The engine oil can
be very hot. In order to avoid poten-
tial burns, do not remove the engine
drain plug if the engine is hot. Wait
until engine oil is warm.
(ALL CLIMATE)