Gearbox Oil - BRP Can-am MAVERICK Trail T Series Operator's Manual

MAINTENANCE PROCEDURES

Gearbox Oil

Gearbox Oil Level Verification
Place the vehicle on a level surface.
Select PARK position.
Check the gearbox oil level by remov-
ing the gearbox oil dipstick.
219001880-038_a
1. Gearbox oil level plug
Remove dipstick again and check oil
level. It should be near or equal to the
upper mark.
tmr2016-106-005_a
1. MIN.
2. MAX.
3. Operating range
To add oil, place a funnel into the dip-
stick hole.
Add a small amount of recommended
oil and recheck oil level.
Repeat the above procedures until
oil level reaches the dipstick's upper
mark.
NOTICE
Operating the gearbox
with an improper oil level may se-
verely damage gearbox.
NOTE: Do not overfill. Wipe off any
spillage.
Properly tighten oil dipstick.
______________
114
Recommended Gearbox Oil
RECOMMENDED GEARBOX OIL
Scandinavia
All other countries
NOTE: The XPS oil is specially formu-
lated to meet the lubrication require-
ments of this gearbox. BRP strongly
recommends the use of its XPS oil.
However, if the XPS synthetic gear oil
is not available, use the following lubri-
cant:
GEARBOX OIL MINIMUM
REQUIREMENT
75W 140 API GL-5 synthetic gear oil
Gearbox Oil Change
NOTE: When replacing the gearbox
oil, it is recommended to clean the ve-
hicle speed sensor (VSS) at the same
time.
Place the vehicle on a level surface.
Clean drain plug area.
Clean the oil level plug area.
Clean the VSS sensor area.
219001880-071_a
Under the vehicle, place a drain pan un-
derneath the oil drain plug area.
75W140
SYNTHETIC
GEAR OIL (EUR)
(P/N 779215)
75W140
SYNTHETIC
GEAR OIL
(P/N 779160)