CONTROLS
NOTE: To allow engine starting, the ig-
nition switch must be in the ON or ON
with lights position and the emergency
engine stop button set to RUN.
Override/DPS Button
Depending on the vehicle model, this
button has up to 2 functions.
Override Function
vmo2012-014-021_d
TYPICAL
1. Override button
The override switch main function is to
bypass the engine speed limiter in re-
verse operation by allowing maximum
engine torque.
WARNING
Only use the override to help get
the vehicle unstuck from mud or
other soft terrain. Do not use the
override for normal operation in
reverse. This would allow driving
in reverse at excessive speeds and
can increase the risk of losing con-
trol.
To engage the override function, pro-
ceed as follows:
While reading this Operator's Guide, remember that:
Indicates a potential hazard that, if not avoided, could result in serious
injury or death.
______________
68
While the shift lever is set to REVERSE
position.
1. Ensure that the vehicle is stopped.
2. Press and hold the override switch
then press the throttle lever gradu-
ally.
NOTE: When using the override func-
tion, the gauge will scroll an OVER-
RIDE message to confirm that the
function is activated.
3. To disengage the override function,
simply release the override switch.
DPS Function (X xc Models)
vmo2012-014-021_d
1. DPS button
The DPS function is used to change the
DPS (Dynamic Power Steering) mode.
To change DPS mode, refer to
YOUR RIDE
9) 2WD/4WD Selector
The 2WD/4WD selector is located on
the RH side of the handlebar.
WARNING
subsection.
TUNE