BRP can-am RENEGADE 500 2015 Operator's Manual page 117

to ensure proper seat when in-
flating. Mount the inner bead
over the wheel like normal.
NOTICE
beadlock side only.
1.2 Seat tire outer bead in the
shoulder of the beadlock in-
ner ring and center the tire.
vbs2010-007-002_a
TYPICAL
1. Tire outer bead
2. Beadlock inner ring shoulder
2. Lubricate all beadlock screws with
LOCTITE 767
BRICANT) (P/N 293 800 070) or
an equivalent product to prevent
screws sticking.
3. Install all beadlock screws. To avoid
cross threading, start all screws by
hand.
NOTICE
Do not use an impact
wrench for
screws. The risk of screw breaking
or screw stripping is high when us-
ing an impact wrench.
Mount tire
(ANTISEIZE
installing beadlock
from
vbs2010-007-004
TYPICAL
4. Tighten beadlock screws as per fol-
lowing specification and sequence.
NOTE: To
on the beadlock clamp ring, tighten
screws a few turns at a time.
Beadlock
screws (FIRST
TORQUE)
LU-
tbl2011-001-068_b
TYPICAL - TIGHTENING SEQUENCE
5. At this time check if the tire is still
centered on wheel. Reposition it if
necessary.
6. Tighten beadlock screws as per the
second torque using the same se-
quence.
Beadlock
screws
(SECOND
TORQUE)
______________
MAINTENANCE PROCEDURES
ensure even
TIGHTENING TORQUE
3 N•m ± 1 N•m
(27 lbf•in ± 9 lbf•in)
TIGHTENING TORQUE
8 N•m ± 1 N•m
(71 lbf•in ± 9 lbf•in)
pressure
115