BRP can-am RENEGADE 500 2015 Operator's Manual page 135

ENGINE TURNS OVER BUT FAILS TO START (cont'd)
3. Spark plug/ignition (no spark).
– Check injectors/ignition fuse condition.
– Remove spark plug then reconnect to ignition coil.
– Check that ignition switch and/or emergency engine stop switch is/are at the
ON position.
– Start engine with spark plug grounded to the engine away from spark plug
hole. If no spark appears, replace spark plug.
– If trouble persists, contact an authorized Can-Am dealer.
4. Multifunction gauge CHECK ENGINE indicator lamp is on and display
shows CHECK ENGINE.
– Contact an authorized Can-Am dealer.
5. Engine is under a protection (limp home) mode.
– Multifunction gauge CHECK ENGINE indicator lamp is on and display shows
CHECK ENGINE, contact an authorized Can-Am dealer.
ENGINE LACKS ACCELERATION OR POWER
1. Fouled or defective spark plug.
– Refer to ENGINE TURNS OVER BUT FAILS TO START.
2. Lack of fuel to engine.
– Refer to ENGINE TURNS OVER BUT FAILS TO START.
3. Engine is overheating. (CHECK ENGINE indicator light will turn on and HI
TEMP will appear in the multifunction display.)
– Refer to ENGINE OVERHEATS.
4. Air filter/housing clogged or dirty.
– Check air filter and clean if necessary.
– Check deposits in air filter housing drain.
– Check the position of the air intake tube.
5. CVT dirty or worn-out.
– Contact an authorized Can-Am dealer.
6. Engine is under a protection (limp home) mode.
– Check multifunction gauge display for messages.
– Multifunction gauge CHECK ENGINE indicator lamp is on and display shows
CHECK ENGINE or LIMP HOME, contact an authorized Can-Am dealer.
ENGINE OVERHEATS
1. Low coolant in cooling system.
– Check engine coolant, refer to ENGINE COOLANT in MAINTENANCE sec-
tion.
2. Dirty radiator fins.
– Clean radiator fins, refer to RADIATOR in MAINTENANCE section.
______________
TROUBLESHOOTING GUIDELINES
133