SMC Networks EX600-SDN Series Operation Manual page 57

Analog input unit parameters
Parameter
No
(EDS
parameter)
Short circuit
detection
1
(Monitor
short circuit)
0~10 V, 1~5 V, 0~5 V,
Analogue
-10~+10 V, -5~+5 V,
2 input range
0~20 mA, 4~20 mA,
(Ch # range)
Analogue
Offset Binary, Sign &
data format
3
(Data
format)
Analogue
2 value average,
4 filter
4 value average,
(Ch # filter)
8 value average
Over range
detection
5
(Monitor
over range)
Under range
detection
6
(Monitor
under range)
User set
7
value upper
limit error
(Analogue
upper limit)
User set
8
value lower
limit error
(Analogue
under limit)
Note) Factory default setting for analogue input range is –10 ~ +10 V
When changing the analogue input measurement range, confirm the set value and set the correct
value accordingly.
Setting value
Enable sensor power supply
Enable
short circuit detection
Disable sensor power supply
Disable
short circuit detection
Select analogue input range
-20~+20 mA
Magnitude, 2s Select analogue data format
complement
None,
Select analogue data filter
If the analogue input exceeds
the maximum allowable input
Enable
range (0.5 %), a diagnostic
error will be generated
Above diagnostic error will not
Disable
be generated.
If the analogue input exceeds
the minimum allowable input
Enable
range (0.5 %), a diagnostic
error will be generated
Above diagnostic error will not
Disable
be generated.
If the analogue input exceeds
the upper user set lower limit,
Enable
diagnostic error will be
generated
Above diagnostic error will not
Disable
be generated.
User set value is settable
Val
according to the table below
If the analogue input falls
below the lower user set lower
Enable
limit, diagnostic error will be
generated
Above diagnostic error will not
Disable
be generated.
User set value is settable
Val
according to the table below.
Setting
Contents
Channel
Channel
Channel
- 57 -
Setting method
Default
level setting By PLC By HT
O
Unit O
-10 ~
O
+10 V
Offset
Unit O
binary
2 value
Unit O
average
Unit Enable O
Unit Enable O
Disable
X
10 V
Note)
Disable
X
10 V
Note)
No.EX##-OML0007
O
O
O
O
O
O
O
O