Connecting To A Power Supply; Fastening The Cable - Christie APS Series User Manual

Connecting to a power supply

1.
Put the connector of the power cord into the
AC (AC inlet) of the projector.
2.
Firmly plug the power cord's plug into the outlet.
In a couple of seconds after the power supply
connection, the POWER/STATUS indicator will
light up in steady orange.
Please remember that when the DIRECT POWER
ON function is activated (71), the connection of the
power supply makes the projector turn on.
When the AUTO POWER ON function is activated and
the projector is receiving an input signal, it is turned on
by connecting to the power supply (71).
WARNING
incorrect or faulty connections may result in fire and/or electrical shock.
• Do not touch the power cord with a wet hand.
• Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one. Never modify the power cord.
• Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Unplug the power cord for complete disconnection.
• Do not distribute the power supply to multiple devices. Doing so may overload
the outlet and connectors, loosen the connection, or result in fire, electric shock
or other accidents.
• Connect the ground terminal for the AC inlet of this unit to the ground terminal
of the building using an appropriate power cord (bundled).
NOTICE
►This product is also designed for IT power systems with a phase-to-
phase voltage of 220 to 240 V.

Fastening the cable

Use the supplied cable tie to fasten the cable.
LWU650-APS/LWU530-APS
User's Manual - Operating Guide
►Please use extra caution when connecting the power cord, as
Cable tie - large
17
Setting up
POWER/STATUS
indicator
020-001523-01 Rev. 1 (11-2018)
LIT MAN USR APS Series
AC
Power
cord