Christie APS Series User Manual page 111

Phenomena that may be easy to be mistaken for machine defects (continued)
Phenomenon
The IR and
RS-232C does
not work on
HDBaseT
connection.
HDBaseT
connection
does not work.
IR and LAN
does not work
via HDBaseT.
LAN does not
work, if LAN is
connected to
the projector
while having
an input signal
from HDBaseT.
(continued on next page)
LWU650-APS/LWU530-APS
User's Manual - Operating Guide
Cases not involving a machine defect
The POWER SAVE/NETWORK-WOL function is
working.
Select NORMAL or QUICK START for STANDBY MODE
item in the SETUP menu.
The POWER SAVE/NETWORK-WOL function is
working.
Select NORMAL or QUICK START for STANDBY MODE
item in the SETUP menu.
The connected equipment may not be supported by
HDBaseT.
Refer to User's manual (detailed) for connection.
Check if the IR setting is OFF under HDBaseT.
EASY MENU > ADVANCED MENU > OPTION >
SERVICE > REMOTE RECEIV.
Check if the LAN setting is HDBaseT.
EASY MENU > ADVANCED MENU > OPTION
> SERVICE > CONTROL TERMINAL > WIRED
NETWORK
Check if the LAN setting is HDBaseT.
EASY MENU > ADVANCED MENU > OPTION
> SERVICE > CONTROL TERMINAL > WIRED
NETWORK
This projector is compatible with 100BASE-T only.
Check the specification of the connected equipment.
If the LAN cable is connected with the hub, try to change
the connected port at the hub.
If the LAN cable is connected directly to the computer,
try to connect to other computer.
109
Troubleshooting
Reference
page
61
61
13
80
83
83
–
–
–
020-001523-01 Rev. 1 (11-2018)
LIT MAN USR APS Series