Christie APS Series User Manual page 84

OPTION menu
Item
SERVICE
(continued)
(continued on next page)
LWU650-APS/LWU530-APS
User's Manual - Operating Guide
COMMUNICATION TYPE
Select the communication type for transmission via
the CONTROL port.
NETWORK BRIDGE: Select this type, if it is required
OFF: Select this mode to receive RS-232C
• OFF is selected as the default setting.
• When you select the NETWORK BRIDGE, check
the item, TRANSMISSTION METHOD (below).
SERIAL SETTINGS
Select the serial communication condition for the
CONTROL port.
BAUD RATE
COMMUNICATION
(continued)
TRANSMISSION METHOD
Select the transmission method for communication by
the NETWORK BRIDGE from the CONTROL port.
HALF-DUPLEX: This method lets the projector
FULL-DUPLEX: This method lets the projector
• HALF-DUPLEX is selected as the default setting.
• If you select HALF-DUPLEX, check the setting of
the item RESPONSE LIMIT TIME (83).
Description
to control an external device as a network terminal,
via this projector from the computer.
The CONTROL port does not accept RS-232C
commands (Network Bridge Function in the
Network Guide)
commands using the CONTROL port.
4800bps ó 9600bps ó 19200bps ó 38400bps
PARITY
NONE ó ODD ó EVEN
HALF-DUPLEX ó FULL-DUPLEX
make two-way communication, but only one
direction, either transmitting or receiving data, is
allowed at a time.
make two-way communication, transmitting and
receiving data at the same time.
82
020-001523-01 Rev. 1 (11-2018)
LIT MAN USR APS Series