Pbyp ( Picture By Picture); Pip (Picture In Picture) - Christie APS Series User Manual

Operating
PbyP (Picture by Picture) / PIP (Picture in Picture)
The PbyP / PIP is a function for displaying two different picture signals on a
screen that is separated into main and sub areas for each signal.
MYBUTTON
INPUT
1 2
PbyP
INPUT MYBUTTON
1 2
ASPECT PbyP AUTO FREEZE
button
ASPECT PbyP AUTO FREEZE
MAGNIFY FOCUS ZOOM VOLUME
ON + + +
OFF - - -
PAGE
UP GEOMETRY PICTURE MUTE
MAGNIFY FOCUS ZOOM VOLUME
DOWN INTERACTIVE NETWORK BLANK
+ +
ON
ESC MENU
ENTER
OSD MSG RESET
-
-
OFF
Press the PbyP button on the remote control. This activates the PbyP mode.
PAGE
UP GEOMETRY PICTURE MUTE
Then, press the PbyP button again. The projector goes into PIP mode. The
screen displayed before the PbyP button was pressed will be displayed as the
DOWN INTERACTIVE NETWORK BLANK
main area. Most of operations are effective for the main area only. Only outputs
the audio input signal paired with the picture input signal for the main area.
ESC MENU
To quit the PIP mode, press the PbyP button again.
ENTER
NOTE
• If the LAN port is selected when the PbyP button is pressed, input
from other port is displayed on the main area.
OSD MSG RESET
• When in the PbyP / PIP mode, use the MENU button on the remote control or
▲/▼ buttons on the control panel to display the OSD menu.
• There are certain functions that cannot be used when in the PbyP / PIP mode.
• A message will be displayed when buttons that cannot be used are pressed
(99). However, note that there are certain unusable buttons for which
messages are not displayed.
• The functions on the OSD menu that cannot be used are displayed in gray
and cannot be selected.
• When in the PbyP / PIP mode, image quality may deteriorate.
(continued on next page)
LWU650-APS/LWU530-APS
User's Manual - Operating Guide
+
Normal mode
-
main sub
ð
area area
PbyP mode
36
main
area
ð
PIP mode
020-001523-01 Rev. 1 (11-2018)
LIT MAN USR APS Series
sub area