10. Using the four screws, re-attach the knockout plate and ensure the appropriate strain relief is
in place.
11. Using the six screws, re-install the rear cover.
Connecting to an uninterruptible power supply
An uninterruptible power supply (UPS) allows the cinema projector head electronics to remain
operable during a power failure.
Warning! If not avoided, the following could result in death or serious injury.
•
SHOCK HAZARD! The optional UPS power cord must be inserted into an outlet with grounding.
1. If installed, remove the touch panel.
2. Loosen the six screws to remove the rear cover.
3. Behind the MAIN input circuit breaker, disconnect the MAIN input plug from the top power
supply.
A
UPS input plug
B
MAIN input plug
4. Remove the protective cap from the UPS input plug.
5. Connect the UPS input plug to the top power supply (A).
CineLife+ 4K-RGB Installation and Setup Guide–CP4415-RGB, CP4420-RGB, CP4425-RGB, CP4435-RGB
020-103244-06 Rev. 1 (06-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up
31