Mitsubishi FX3U Series Programming Manual page 373

Hide thumbs Also See for FX3U Series:

Table of Contents

Series Programmable Controllers

Programming Manual - Basic & Applied Instruction Edition

5. Program example

1) Circuit diagram

In the sequence circuit shown below, all areas except shaded areas are standard.

Program the shaded areas according to the contents of control.

a) Initial circuit

While the machine is operating, the operation mode can be switched arbitrarily (among stepping

operation, cycle operation and continuous operation) in the automatic mode.

When the operation mode is switched among the individual operation mode, zero return operation

mode and automatic mode while the machine is operating, all outputs are reset once to assure safety.

And then the mode after switching becomes valid.

(While M8045 (All output reset disable) is ON, outputs are not reset at all.)

Ladder block

b) Individual operation mode

Programming is not required when the individual operation mode is not provided.

Initial state

for individual

Detects that the machine is located at the zero point, and

regards it as the condition to start the automatic mode.

State number

Clamping command

command Y000

command Y002

Leftward travel

Rightward travel

14 Handy Instruction – FNC 60 to FNC 69

Zero point condition

Initial state

14.1 FNC 60 – IST / Initial State

Fx3uc series Melsec-f