Table of Contents
Advertisement
38
8.4 Speed measuring system
For optimum functionality, all the DIP−switches (S1−S6) for the speed mea
suring system must be in the "OFF" position (factory setting).
Fig. 8.5: Switches for setting the speed measuring system
8.5 Form of speed output signal
In the factory setting, two 90_ phase−offset speed signals (5 V symmetrical,
complementary RS422 signals) are available at the speed output (connector 2).
8.6 Type of speed output signal
You can use switch S7 to change the symmetrical 5 V output signal (factory
setting) to an asymmetrical signal of 0 V ... 5 V.
Switch S7
Fig. 8.6:
Switch S7; symmetrical/asymmetrical output signal
HBM
Switches S1 ... S6
symmetrical
asymmetrical
Pos. 2
Pos. 1
T10FH
A2037−4.0 en
Advertisement
Table of Contents
