Table of Contents
Advertisement
36
T10FH
End point
Zero point
Fig. 8.2: Setting the voltage output zero point
8.3 Function testing
8.3.1 Power transmission
If you suspect that the transmission system is not working properly, you can
remove the stator cover and test for correct functioning. If the LED is on, the
rotor and stator are properly aligned and there is no interference with the
transmission of measurement signals. When the shunt signal is triggered, the
LED shines more brightly.
Control LED
Fig. 8.3: Power transmission function test
HBM
A2037−4.0 en
Advertisement
Table of Contents
