Supply Voltage (Option 3, Code Pnj); Teds Transducer Identification (Option 3, Code Pnj); Hierarchy Of User Rights; Standard Rights (Usr Level) - HBM T10FH Mounting Instructions

Torque flange

Hide thumbs Also See for T10FH:

Table of Contents

CAUTION

The instant you switch on, a current of up to 2 A may flow and this may

switch off power packs with electronic current limiters.

5.6 Supply voltage (Option 3, Code PNJ)

A ready−made 6 wire transducer connection cable with free ends can be re

quested as an accessory.

Extension cables should be shielded and of low capacitance. HBM provides

specific cables for this purpose, the 1−KAB0304A−10 (ready−made) and the

KAB8/00 2/2/2 (by the meter).

The pin assignment can be found in the table in section 5.4.

For the pin assignments at the amplifier end, please refer to the relevant am

plifier documentation.

TEDS stands for "Transducer Electronic Data Sheet". An electronic data sheet

can be stored in the transducer as defined in the IEEE1451.4 standard, mak

ing it possible for the amplifier to be set up automatically. A suitably equipped

amplifier reads out the transducer characteristics (electronic data sheet),

translates them into its own settings and measurement can then start.

The digital identification system is available at plug connection PIN 7 to PIN 2.

The HBM TEDS Editor is used to store the data. This is included in the HBM

"MGCplus Setup Assistant" software. You can use the Editor to manage differ

ent user rights, thus protecting the essential transducer data from being over

written by mistake.

This level concerns rights which the user of the transducer needs in order to

change the entries which depend on the conditions of use.

This level concerns the rights needed by a calibration laboratory, for example,

if the sensitivity in the TEDS memory is to be changed.

HBM

T10FH

A2037−4.0 en

Table of Contents