Aligning The Stator (Speed Measuring System) - HBM T10FH Mounting Instructions

Torque flange

Hide thumbs Also See for T10FH:

Table of Contents

T10FH

Support supplied by customer

Clamp fixture

Antenna ring

Fig. 4.8: Supporting the antenna ring

4.8 Aligning the stator (speed measuring system)

The stator can be mounted in any position (for example, "upside down" instal

lation is possible).

For measuring mode to operate perfectly, the speed sensor must be placed at

a defined position to the rotor ring gear.

NOTE

To fasten the stator, we recommend the use of M6 screws with plain

washers (width of oblong hole, 9 mm). This size of screw guarantees the

necessary travel for alignment.

Axial alignment

At the factory, the head of the speed measuring system sensor must be ad

justed so that when the axial alignment of the stator is exact (antenna ring

positioned precisely above the rotor winding carrier), the sensor is in the cor

rect position to the ring gear.

HBM

A2037−4.0 en

Table of Contents